Features and Benefits

Economical Gas Heat

  • Easy to Set Up for Natural Gas or Propane
  • High Altitude Pressure Switch Kit Allows Operation from 6,000 to 10,000 ft. (1,830 to 3,050 meters) Using Propane or Natural Gas
  • Optional Vertical Vent Pipe Kits

R-410A Refrigerant

  • Efficient Heat Release
  • Non-Ozone Depleting Refrigerant
  • Synthetic Lubricant
  • Reduced Compressor Wear

Patented Technology

  • Tubular Heat Exchanger with Integral Formed Dimple Turbolator
  • Clean and Quiet “Inshot” Stainless Steel Gas Burners

Ease of Installation and Service

  • Easily Accessible Electrical Box and Compressor
  • Built-In Mounting Flanges and Internal Disconnect
  • Standard Access Valves and Filters, Status LEDs

Contact Eubank Sales:

Toll Free: 1-888-726-2734

Email: eubankorders@airxcel.com

HAA Wall Mount Air Conditioners w/Gas Heat


Eubank WalPac A/C+G Air Conditioner with Gas Heat

The Eubank HAA vertical package exterior wall mounted air conditioner with gas heat is designed for use on a variety of applications including modular classrooms, relocatable offices and a multitude a permanent buildings. The HAA unit is manufactured in two cabinets with nominal cooling capacities of 2, 2-1/2, 3, 3-1/2, 4, and 5 tons and input heating capacities of 45,000; 67,500; 75,000; 90,000; 100,000 and 125,000 BTUHs. The Eubank HAA is available with a number of factory and field installed options and accessories which permit the user to optimize the unit for specific applications.


AHRI Certified

Safety Listed & Energy Certified

All Eubank air conditioners are built to UL standard 1995, 4th edition and CAN/CSA C22.2, No. 236-11. The units are listed by ETL and tested to the American National Standard/CSA Standard for Gas Fired Central Furnances; ANSI Z 21.47 -2006/CSA 2.30-2006. For energy efficiency and performance, the units are tested and rated in accordance to the ANSI/AHRI (Air-Conditioning Heating and Refrigeration Institute) Standard 390 (Single Package Vertical Units). All AVGA units meet or exceed the efficiency requirements of ANSI/ASHRAE/IESNA 90.1.2007.

Eubank HAA air conditioners are commercial units and are not intended for use in residential applications

Ease of Installation
  • Built-in mounting flanges eliminate need for side brackets
  • Sloped top sheds water, minimizes chance of water leaks and eliminates the need for a rainhood
  • Top flashing piece and bottom mounting bracket provided on all units
  • Electrical knockouts on back and side
  • Gas connection on the right side
  • Power disconnect
Economical Gas Heat
  • Factory set up for natural gas with easy conversion in field to propane
  • Natural gas high altitude pressure switch kit allows operation in sites from 6,000 to 10,000 ft. (1,830 m to 3,050 m)
  • Propane high altitude pressure switch kit allows operation in sites from 6,000 to 10,000 ft. (1,830 m to 3,050 m)
  • Vertical vent pipe kits
Ease of Service
  • Compressor and electrical box are easily accessible
  • Refrigerant access values allow quick check of refrigerant pressures
  • Easily accessible filter
  • LED identifies operating status and simplifies service by flashing fault code in heating mode
  • Copper tube, aluminum fin evaporator and condenser coils
Protection of Refrigeration System Components
  • High and low pressure switches
  • Compressor time delay
Low Ambient Operation in Cooling Mode
  • Condenser fan cycles allowing cooling to 20°F (-7°C)
Patented Tubular Heat Exchanger with Integral Formed Dimple Turbulator
  • Enhanced heat transfer for optimum efficiency
  • Quiet – eliminates noise caused by expansion and contraction of internal baffles
Patented Inshot Gas Burners
  • Quiet, clean burning gas inshot burners fire in a direct line with the orifice and the tube
  • Unique carryover design (cross lighting from one burner to another) for immediate lighting
  • Optional stainless steel burner
Direct Spark Ignition Control System with LED Flash
  • Fault Indicator
  • Thirty second purge of heat exchanger prior to ignition
  • Three ignition trials before lockout
  • Sixty second post purge at end of operating cycle prevents nuisance trips of rollout switch
  • One hour automatic reset after lockout – eliminates need to manually recycle on lockout
  • LED identifies operating status and simplifies service by flashing fault code
Eubank V and H Series Wall Mount Air Conditioners and Heat Pumps

Product Literature

Eubank HAA1024A-1060A I-O Manual (Rev.2) (pdf - 3332 KB)
Eubank HAA1024A-1060A Product Data Sheet (Rev.3) (pdf - 2060 KB)